Hmm, 7 hours later and this is where I'm at, finger keeps hovering over abort button, any suggestions?
--- Vis ---
saveprt = true
3159 portalclusters
10425 numportals
5322 numfaces
20850 active portals
0 hint portals
visdatasize:1263608
--- BasePortalVis (20850) ---
0...1...2...3...4...5...6...7...8...9... (244)
8 average number of passages per leaf
218 MB required passage memory
--- CreatePassages (20850) ---
0...1...2...3...4...5...6...7...8...9... (668)
--- PassagePortalFlow (20850) ---
0...1...2...3...4...5...
Looong compile, to quit or go on?
Moderators: Nexuiz Moderators, Moderators
5 posts
• Page 1 of 1
Looong compile, to quit or go on?
by Rad Ished » Tue Dec 11, 2007 10:02 am
- Rad Ished
- Keyboard killer
- Posts: 609
- Joined: Wed Jun 27, 2007 8:00 am
- Location: Not the Netherlands
by divVerent » Tue Dec 11, 2007 10:26 am
This is still in the vis stage...
you should probably abort, and check if you can make some small brushes detail brushes and only the big ones that block vision structural.
you should probably abort, and check if you can make some small brushes detail brushes and only the big ones that block vision structural.
1. Open Notepad
2. Paste: ÿþMSMSMS
3. Save
4. Open the file in Notepad again
You can vary the number of "MS", so you can clearly see it's MS which is causing it.
2. Paste: ÿþMSMSMS
3. Save
4. Open the file in Notepad again
You can vary the number of "MS", so you can clearly see it's MS which is causing it.
- divVerent
- Site admin and keyboard killer
- Posts: 3809
- Joined: Thu Mar 02, 2006 4:46 pm
- Location: BRLOGENSHFEGLE
by divVerent » Tue Dec 11, 2007 10:38 am
did you already use detail brushes?
1. Open Notepad
2. Paste: ÿþMSMSMS
3. Save
4. Open the file in Notepad again
You can vary the number of "MS", so you can clearly see it's MS which is causing it.
2. Paste: ÿþMSMSMS
3. Save
4. Open the file in Notepad again
You can vary the number of "MS", so you can clearly see it's MS which is causing it.
- divVerent
- Site admin and keyboard killer
- Posts: 3809
- Joined: Thu Mar 02, 2006 4:46 pm
- Location: BRLOGENSHFEGLE
by Rad Ished » Tue Dec 11, 2007 11:11 am
Yeah i already did detail brushes, but not very well it turns out. Did it again, hid everything as i went, pressed invert when there was nothing but micros and deleted a fair bit of rubbish, duh! or even dhu!
- Rad Ished
- Keyboard killer
- Posts: 609
- Joined: Wed Jun 27, 2007 8:00 am
- Location: Not the Netherlands
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest